Crack-bridging mineral, white, elastic coating. It has high resistance to mineral oils and aliphatic hydrocarbons. Resistant to pressurized water and mineral oils.

Properties

• two-component, solvent-free, liquid consistency
• flexible and crack bridging waterproofing material
• very high adhesion to wet and dry surfaces
• liquid consistency, thanks to which it is very easy to apply, even on complex structural elements
• coating resistant to UV radiation, which allows it to be used outdoors and indoors
• the white color reflects solar radiation, preventing the coating from heating up
• the coating has a short setting time
• high flexibility,
• resistance to aging, poor pedestrian traffic, hydrolysis and de-icing salts
• frost-resistant product
• the material is resistant to oil in synthetic and aliphatic hydrocarbons at high boiling point (up to 2 bar)
• the product is not resistant to substances containing aromatic hydrocarbons such as benzene, xylene, toluene
• does not contain volatile organic substances (VOC = 0),
• does not contain polyurethane, isocyanate or bitumen

Application

• underfloor waterproofing in buildings
• waterproofing foundation in (on the side of pressing water)
• waterproofing the tank in the flat roof above unheated rooms
• insulation under ceramic cladding, on terraces, balconies, it can also be used as a protective coating against mineral oils and aliphatic hydrocarbons
• Suitable for use as surface protection against mechanical and chemical stress, e.g. in oil sedimentation tanks
• good adhesion to masonry surfaces, concrete, cement screeds, metal, bitumen and PVC

Technical data

• White color
• pasty consistency
• mixing ratio (by weight) 2: 3 (A: B)
• application temperature from +5 C to +35 C
• substrate temperature minimum +5 C
• time to use the material after mixing approx. 45 min (1 kg of material at the temperature of +23 C)
• one layer thickness 0.5-2.0 mm
• crack bridging up to 0.4 mm
• density 1.55 g / cm ³
• CO ₂ permeability: S _d CO ₂ = 924 m
• water vapor permeability S _d <10 m (Class II)
• capillary absorption and water permeability w = 0.011 kg / m ² xh ^0.5
• thermal compatibility (with de-icing salts) meets the requirements of EN 1504-2: 2004
• tear adhesion ≥ 1.0 N / mm ²
• the product complies with the European standard EN 1504-2: 2004
• consumption 2.5-3.0 kg / m ²
• package 20 kg set