Neotherm - polystyren Neodach Floor Premium
cena na vyžádání
propagační cena
jednotková síť
1481,94Kč pro m3
minimální komerční
množství produktu
1.00 m3
propagační cena
hrubá jednotka
1822,78Kč
pro m3
minimální komerční
množství produktu
1.00 m3
celková cena
propagační sleva
1822,78Kč
pro 1.00 m3
Popis produktu
Neodach Premium Floor Styrofoam board is designed for thermal insulation in buildings with a payload of up to 2.1 tons / m2, has specific physical and mechanical properties, natural hydrophobicity, dimension stability after application, good thermal insulation properties, as well as high mechanical strength. It is also resistant to aging. In addition, the plate is absolutely ecological, free of compounds in FCKW, which destroy the ozone layer, safe for health, does not irritate the skin and does not cause allergies.
Application
- in accordance with RTQ ITB Technical and Quality Recommendation -1212/2010, in particular roof insulation and with usable load of up to 2.1 t / m2
- for thermal insulation of the roof in flat and sloping, new and regenerated
- for thermal insulation of floors on the ground and on a reinforced concrete ceiling normally loaded
attention
Styrofoam boards are produced with two types of edges with dimensions:
not milled 1000 x 500 mm panel thickness from 10 to 500 mm in steps, every 10 mm, milled at the plant 980 x 480 mm panel thickness from 50 to 150 or 200 mm (depending on the production plant) in steps, every 10 mm. Milled edges: additional payment PLN 5.00 / m3. Please provide information about the thickness and finish of the panel edges in the commentary to the order. Due to frequent price movements, for reasons beyond our control, please confirm the price each time you buy.
Technické údaje - vlastnosti
- délka (třída rozměrových tolerancí):
- ± 3 mm
- pevnost v ohybu:
- ≥ 115 kPa
- požární klasifikace - reakce na oheň:
- E
- pravoúhlost (třída rozměrových tolerancí):
- ± 5/1000 mm / mm
- rovinnost (třída rozměrové tolerance):
- ± 10 mm
- rozměrová stálost za konstantních normálních laboratorních podmínek DS (N) 5:
- ± 0,5 %
- rozměrová stálost za určitých podmínek teploty a vlhkosti DS (70,-) 2:
- <= 2 %
- šířka (třída rozměrových tolerancí):
- ± 3 mm
- součinitel tepelné vodivosti λ:
- 0,039 W / mK
- tlakové napětí při 10% relativní deformaci:
- ≥ 70 kPa
- tloušťka (třída rozměrových tolerancí):
- ± 2 mm
- živé zatížení [t/m²]:
- ≤ 2,1 t / m
Přílohy