EPS 040 facade foam boards can be used in applications requiring low mechanical loads, in particular for thermal insulation in the following places:

• walls made using the "light wet" (BSO, ETICS) method or "light dry" method,
• surfaces of skeleton walls,
• crevices of closed or ventilated three-layer walls,
• wreaths, jambs, lintels and other places exposed to thermal bridges,
• balcony loggias,
• layered walls;
• continuous outer layers of skeleton walls,
• wreaths in the formwork method lost to plaster,
• floors from below with the "light wet method",
• reinforced concrete floors,
• steep roofs under and between the rafters.
• In particular, for thermal insulation in the following places:
• diaphragm walls with ventilated and non-ventilated air gap,
• expansion joints in constructions,
• in internal partitions,
• walls in frame construction with cladding,
• floors from below with cladding,
• floors between joists,
• light skeleton ceilings with cladding,
• insulation between rafters,
• ventilated flat roofs.

attention

Milled edges "overlapped": surcharge 8.00 PLN / m³. Please provide information about the thickness and finish of the panel edges in the commentary to the order. Plate thickness range: from 10 to 300 mm. Due to frequent price movements, for reasons beyond our control, please confirm the price each time you buy.